Installation instructions
21
Connecting the feeder cable
To connect the feeder cable to the cooker: Remove the screws securing the
cover “A” on the rear of the cooker. Feed the supply cable through the cable clamp “D”. See the ‘Feeder cable section’ following for the correct size for the cable.
Connect the wires to the terminal block “B” as shown in the diagram; or connect the phase wires to the terminal block “B” and the earth wire to the terminal PE as shown.
Take up any slack in the cable and secure with the cable clamp “D”. Replace the cover “A”.
N.B. The earth conductor must be left about 3 cm longer than the others.
PE |
N | D | |
L | ||
| ||
B |
|
A
Figure 16a Connecting the feeder cable
Power Supply
230V - 50Hz 4500W 19,5A (230V)
Feeder cable section “TYPE
230V | 3 x 2.5 mm2 (**) |
(**)- Connection with wall box connection.
PEPE
NL NL
230 V
L1 N PE (L2)
Earth
Earth
Neutral
Neutral
Live
Live