Fisher & Paykel OR90SDBGFPX Using the Self Clean function, To cancel a Self Clean cycle

56

Using the Self Clean function

3Select the Self Clean Function

The display will show P1:30 A

The P will flash

4Adjust the cycle time (optional)

You may set the time between 1-1/2 hours (P1:30 and 3 hours (P3:00). For normal soiling use a 3 hour cycle. For light or localised soiling decrease the time.

Press the button - the P will go out.

Use the and buttons to change the time. After a few seconds the P will start to flash again.

Alternatively, press the Start button and the P will flash.

5Start the cycle

Press the Start	button. The P will stop flashing.
The oven will come on and the		indicator will show in the display.

After a few seconds the door will lock and the door lock indicator light will come on. The display will start to count down.

Note: If the door is not shut completely, after a few minutes the oven will switch off, the display will show ‘Fdor’ and the oven will beep. See ‘Troubleshooting’.

6At the end of the Self Clean cycle

The oven will turn off.

The display will show P:00 and a flashing A.

7Turn the function dial to o (Off).

The door will remain locked.

The door lock indicator will remain on.

The display will show ‘hot’.

When the oven has cooled to a safe temperature, the door lock indicator will go out and the door will unlock. The display will show the time of day. This may take 30 minutes.

Note: The oven will still be very warm. To avoid burns, wait for the oven to cool completely before wiping out the ash and replacing side racks and shelves.

To cancel a Self Clean cycle

Turn the function dial to o (Off).

Note: The oven door will remain locked until the oven has cooled to a safe temperature. The door lock indicator light will remain on, and the display will show ‘hot’.