Fisher & Paykel OR90SDBGFPX Installation instructions, Fitting the anti-tiltbracket

Installation instructions

Fitting the anti-tilt bracket

11

Important!
To restrain the appliance and prevent
it tipping accidentally, the anti-	Dotted line showing the position
tilt bracket and restraining plate
	of the cooker when installed
supplied must be fitted according to
the instructions below.
1 Drill four 8mm diameter holes for		Fig. 4 Attaching the
the fixing screws (two in the wall
		anti-tilt bracket and
and two in the floor-see Fig.4) and
	Anti-tilt	sliding the cooker
insert the plastic plugs supplied.	bracket	into place
	Rear left
Important!
	foot of cooker

Before drilling the holes, check that you will not damage any pipes or electrical wires.

2 Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in Fig. 4.

3After attaching the anti-tilt bracket securely,

slide the cooker into place. Ensure that the left rear foot slides under the bracket, as shown in Fig.4.

4Access the bracket by removing the drawer

(Fig. 5):		Fig. 5 Accessing the anti-tilt bracket
a	Slide out the drawer completely.	by removing the drawer
b	Press the lever of the left guide rail	Restraining plate
	down and pull the lever of the right
	guide rail up.
c	Holding the levers, disengage and
	remove the drawer.
d	If fitted, remove kickstrip
	(see ‘Levelling the cooker’)
5 Fix the restraining plate by sliding it into		Screw & Washer
place and securing it with the fixing screw		Fig. 6 Fixing the restraining plate
and washer supplied. See Fig. 6.
6 Replace the drawer (Fig. 7):
a	Insert the drawer rails into the guide
	rails.
b	Gently push the drawer in
	completely; the safety catches will
	automatically hook.
7 Replace the kickstrip using the two screws.
Important!
Beware of sharp edges when removing or

replacing the drawer. Fig. 7 Replacing the drawer