EN 10 Installation instructions
5. Installation (all models)
Your Fisher & Paykel Active Smart™ refrigerator is fitted with front and rear rollers, designed for moving the product in the forwards and backwards direction.
Avoid moving the product in a sideways direction as this may damage the rollers or the floor covering/ surface.
1Your refrigerator will arrive with the front leveling feet wound up making moving this product into its final location a simple task.
2Roll the refrigerator into its final position making sure there is the correct air gap between the product and the surrounding cabinetry. See minimum clearance in cabinetry dimensions table (refer to page 7).
3Using a hex headed screwdriver, or socket set,
turn the front adjustment screws ( a ) clockwise |
|
|
to raise the product and counterclockwise to |
|
|
lower the front of the refrigerator. | a | a |
|
| Fig.3 Adjustment screws |
4Ensure product is sitting backward with the front approximately ⁄” (10 mm) higher than the back. This will ensure a good
5Align your refrigerator with cabinetry:
a Align the sides of the refrigerator with cabinetry by adjusting the
b Adjust the
cOnce the refrigerator is in place and aligned
with the cupboards/alcove, push gently on the |
|
front top and check if the product is rocking or |
|
stable. If the product is rocking, refer to steps |
|
7 – 10. | Fig.4 Toe grille installation |
|
dIf the product is stable and no door leveling is required, place toe grille onto the bottom of the product (refer to figure 4):
Align the toe grille mounting clips with the lower cabinet slots.
Push the toe grille firmly until it snaps into place.
