Fisher VCC-WB2000 Connections, Basic Connections, – 9 –, 2 Connect the power supply, 1 Connect the camera to a computer, 3 Insert the power cord plug into a wall outlet

Connections

Turn off the power for all equipment before making any connections.

Basic Connections

1 Connect the camera to a computer.

Connect a cable between the ETHERNET connectors of the camera and the computer.

Use a crossed wire-type Ethernet cable.

2 Connect the power supply.

When using this unit, the supplied clamping core A must be installed on the power cord, in order to prevent electromagnetic interference to the other devices connected.

•

•

If using a commercially-available 24 V AC adapter, always be sure to connect the ground wire (18AWG or higher) to the ground terminal. (Figure 1 )

If using a 12 V DC power supply, make the connections as shown in Figure 2 .

Note:

•

•

In order to avoid any problems with the camera and the power supply, take sufficient care to ensure that the polarities are correct when connecting the power supply.

When the accessory ferrite cores are attached, they will increase the load on the cable, so after doing the installation, adjust the cable accordingly.

3 Insert the power cord plug into a wall outlet.

The POWER indicator (A) will illuminate.

Computer

				PC CARD
MONITOR	ETHERNET			RS-232C
OUT
(A)			AC24V	GND
PC
POWER 1 2
MODEM			DC12V
ALARM IN		OUT
			CLASS 2 WIRING

A

Ethernet cable

(crossed wire-type cable)

24 V AC connection		12 V DC connection
AC24V	GND	AC24V	GND
DC12V		DC12V
Figure 1		Figure 2

English – 9 –