Start the web browser on the computer.
Turn on the power for the camera.
3
4
5 Type http://192.168.0.2 into the location bar of the web browser, and then press the [Enter] key.
The password entry window will be displayed.
2 Use an Ethernet cable to connect the ETHERNET connector of the camera to the computer.
To make an external connection between the camera and the computer, refer to “Basic connection ” in the “Connections ” section. (p. 9)

Network Camera Settings

2 Computer and Camera Settings

Once the plug-in software has been installed, use the computer’s web browser to access the camera.

Note: The network camera handles large volumes of image data that has been compressed into JPEG2000 format. In order to provide smooth access to the camera, you should close any other applications that you do not need to have open.

1 Click on the Network icon in the

computer ’s Control panel, and then set the computer’s IP address and subnet mask.

•ΙΠ αδδρεσσ: Type in “192.168.0.*”. The camera’s IP address is set to “192.168.0.2”, so set “*” to “3” or greater.

•Συβνετ ∝ασκ: Type in “255.255.255.0”.
6 Type in “ ID3” as the Username and“3333” as the password, and then click the [OK] button.The language selection window will be displayed.

Note: In order to carry out the various settings listed here, you need to enter the password “3333” that has been set for administrator level access at the time of shipment from the factory. Different passwords can be set for up to three access levels. Refer to “Network Settings ” for details on setting the passwords. (p. 18)

Language selection window

– 16 –

English