TROUBLESHOOTING GUIDE
PROBLEM |
| CAUSE |
| CORRECTION |
Treadmill will not start | 1. Not plugged in | 1. | Plug into three prong grounded outlet | |
| 2. | Not turned on | 2. | Turn the on/off button on |
| 3. | Safety Key not on correctly | 3. | Put Safety Key on Console where |
|
|
|
| indicated |
| 4. | Circuit Breaker opened in home | 4. | Reset home breaker |
| 5. | Treadmill Circuit Breaker tripped | 5. | Reset Treadmill Circuit Breaker |
|
|
|
| (see below) |
_____________________________________________________________________________________________________________
Treadmill Speed Surges 1. Motor Controller not set properly 1. Call
_____________________________________________________________________________________________________________
Treadmill Belt will not move - | 1. Lost speed input signal | 1. Call |
ERR 1 on screen |
|
|
_____________________________________________________________________________________________________________
Incline will not operate - | 1. Lost incline signal | 1. Remove and replace Safety Key and |
ERR 3 on screen |
| Treadmill will recalibrate |
_____________________________________________________________________________________________________________
Treadmill Belt Slipping | 1. | Walking Belt loose | 1. | Tighten Walking Belt (see page 13) |
| 2. | Deck needs lubrication | 2. | Lubricate Belt and Deck (see page 14) |
_____________________________________________________________________________________________________________
Treadmill Noisy | 1. | Loose hardware | 1. | Tighten all visible Screws, Nuts, and Bolts |
| 2. | Motor straining | 2. | Check Belt tension - 3 finger test |
|
|
|
| (see page 13) |
| 3. | Clicking sound - Roller knocking | 3. | Adjust Rear Rollers - check for tension |
|
|
|
| (see page 13) |
_____________________________________________________________________________________________________________
Inaccurate pulse rate | 1. | Too much hand movement | 1. | Stand on Side Rails to get accurate |
|
|
|
| pulse reading |
| 2. | Palms too wet | 2. | Dry palms |
| 3. | Gripping hand grips too tight | 3. | Grip using moderate pressure |
| 4. | Wearing rings | 4. | Remove all rings |
_____________________________________________________________________________________________________________
Inaccurate heart rate strap | 1. Electrical interference | 1. Keep at least six feet away from |
|
| Televisions, Computers and |
|
| Fluorescent Lights |
CAUTION
safety switch
on/off switch
The Treadmill will shut off when the electricity load
is above it’s capacity (example: power surge or storm). To restart the Treadmill, please follow the procedure below:
A.Unplug the power cord from the Treadmill’s socket.
B.Push in the safety switch.
C.Plug the power cord back into the Treadmill’s socket.
NOTE: DON'T PUSH IN THE SAFETY SWITCH BEFORE UNPLUGGING THE TREADMILL’S POWER CORD.
power cord
29
