Fitness Quest Brutus 655 manual Slide on easier Slide Short Foam Grips onto ends

FIGURE 11

Step 62. Push 1” x 2” END PLUGS (73) into ends of LEFT BENCH PRESS FRAME (33).

Step 63. Push 3/4” BUSHINGS (70) into LEFT BENCH PRESS FRAME (33).

Step 64. Attach LEFT BENCH PRESS FRAME (33) to LEFT VERTICAL FRAME (5) with 5/8” x 6-3/4” SHAFT BAR (60), 5/8” WASHERS (65) and 5/8” LOCKNUTS (66).

Step 65. Lift LEFT BENCH PRESS FRAME (33), insert STOP ROD (35) and lower LEFT BENCH PRESS FRAME until it rest on STOP ROD.

NOTE: Make sure STOP ROD is locked around LEFT OBLIQUE FRAME (4).

Step 66. Attach two PULLEYS (76) to LEFT BENCH PRESS FRAME (33) with 3/8” x 5-1/8” HEX BOLT (58), 3/8” WASHERS (62) and 3/8” LOCKNUT (67).

Step 67. Attach LEFT PRESS ARM (34) to LEFT BENCH PRESS FRAME (33) with 3/8” x 3” HEX BOLT (54), 3/8” WASHERS (62) and 3/8” LOCKNUTS (67).

Step 68. Push 1” ROUND END PLUGS (74) into ends of LEFT PRESS ARM (34) and slide 2” SQUARE END CAPS (72) over ends.

Step 69. NOTE: Liquid soap applied to LEFT PRESS ARM (34) will help SHORT FOAM GRIPS (85)

slide on easier.							5
Slide SHORT FOAM GRIPS onto ends of
							LEFT
LEFT PRESS ARM until flush with end.				65			VERTICAL
				5/8”			FRAME
				WASHER
		76		66			73
FIGURE 11		PULLEY		5/8”	70		1” x 2”
				LOCKNUT			END PLUG
	67	62			3/4”
					BUSHING
	3/8”	3/8”
	LOCKNUT	WASHER
	54						60
74	3/8” x 3”						5/8” x 6-3/4”
1”	HEX BOLT				35		SHAFT BAR
ROUND	34	62
		3/8”			STOP ROD
END PLUG	LEFT						65
		WASHER
	PRESS
							5/8”
	ARM
					62	WASHER
					3/8”		66
					WASHER		5/8”
		67					LOCKNUT
					33
85	72	3/8”					58
SHORT	2”	LOCKNUT			LEFT BENCH
							3/8” x 5-1/8”
FOAM	SQUARE				PRESS FRAME
							HEX BOLT
GRIP	END CAP				4
	85			74	LEFT
					OBLIQUE
	SHORT			1”
					FRAME
	FOAM		ROUND
	GRIP		END PLUG

26