FIGURE 14
Step 80. Attach two PULLEYS (76) to DOUBLE BRACKET on RIGHT BENCH PRESS FRAME (20) and DOUBLE BRACKET on RIGHT OBLIQUE FRAME (2) with 3/8” x
Step 81. Insert PULLEY (76) into SLOT of RIGHT OBLIQUE FRAME (2) and LEG EXTENSION FRAME
(14)and fasten with 3/8” x
Step 82. Attach a PULLEY (76) to five SINGLE BRACKETS with 3/8” x 2” HEX BOLT (51), 3/8” WASH- ERS (62) and 3/8” LOCKNUT (67).
Step 83. Attach a PULLEY (76) to one side of DOUBLE PULLEY BRACKET “A” (39) and one side of DOUBLE PULLEY BRACKET “B” (40) with 3/8” x 2” HEX BOLT (51), 3/8” WASHERS (62) and 3/ 8” LOCKNUT (67).
Step 84. Insert EYE END of LEG CABLE (94) under PULLEY (76) in LEG EXTENSION FRAME (14), and then insert around all remaining PULLEYS as shown in FIGURE 14 and DETAIL. Follow the cable route starting at position “A” and ending with position “N”.
Step 85. Attach CHAIN (91) to end of LEG CABLE (94) with CHAIN HOOK (90).
Step 86. Attach other end of CHAIN (91) to PRESS CABLE (55) with CHAIN HOOK (90).
NOTE: The CHAIN is used to remove large amounts of slack in cable. The HEFT CABLE AD- JUSTER is used to remove small amounts of slack.
Step 87. Make sure LEG CABLE (94) is riding in groove of PULLEYS (76).
30
