Configuring widgets | Dashboard |
To configure a Trap Console widget, select Add Trap Console in Add Widgets, follow the instructions in the table below, and select OK. If you want to edit an existing Trap Console widget, select the Edit icon in the widget and then follow the instructions in the table below. Select OK to save the changed settings.
Figure 14: Trap Console
Name | Enter the name of the trap console (for example, | |
| Trap_Console_Headquarters). | |
Device Filter | Select the device or devices that the information is gathered from. Use | |
| the arrows to move devices over to the right column. | |
Category | Select the category of traps to include in the trap console. | |
Trap Filter | Select the available traps within the selected category. You can | |
| specify one, multiple, or all trap filters using the arrows to move the | |
| traps to the right column. | |
| Add all | Add all the available traps within the category |
|
| to the right column. |
| Remove all | Remove all the available traps within the |
|
| category back to the left column. |
OK | Select to save the settings (current session only). | |
| Note: You must select Customize > Save Settings from the | |
| Dashboard if you want your settings to be saved permanently. | |
•
Configuring the Report widgets
The Report widgets provide information that is gathered from logs on devices, such as traffic activity, viruses and web activity. Each report can be displayed either as a bar or pie chart. From anywhere in a chart, you can drill down to view
The seven available report widgets are:
•Traffic Report – provides information about network traffic based on traffic logs
| FortiGuard Analysis and Management Service Version 1.2.0 Administration Guide |
30 |
