Configuring a device to use the service | Setup |
To configure remote logging to the service
1In the FortiGate
Figure 5: FortiGuard logging options in Log Setting
2Select the Expand Arrow beside Remote Logging to reveal the available options.
3Select FortiGuard Analysis Service.
If this check box is grayed out, authorize the device from the portal web site and configure the Service Account ID before performing this step. For more information, see “To configure the Service Account ID and validate connectivity” on page 16.
4From “When log disk is full”, select what the service should do when the device reaches its quota: either Overwrite oldest logs or Do not log.
5From “Minimum log level”, select one of the following log severity levels:
0 | - Emergency | The system has become unstable. |
1 | - Alert | Immediate action is required. |
2 | - Critical | Functionality is affected. |
3 | - Error | An error condition exists and functionality could be affected. |
4 | - Warning | Functionality could be affected. |
5 | - Notification | Information about normal events. |
6 | - Information | General information about system operations. |
Messages with an equal or lesser severity will be sent to the service.
6Select Apply.
Note: Daylight Savings Time (DST) may affect your location. It is recommended to verify if your location observes this change, since it affects the accuracy and schedule of logs. For more information, see the Fortinet Knowledge Center article, New Daylight Saving Time support.
To configure remote management by the service
1In the FortiGate
| FortiGuard Analysis and Management Service Version 1.2.0 Administration Guide |
18 |
