WIRING: 9-PIN Connector Cont.

Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)

This wire activates when the unlock button on the remote is pressed a second time within 15 seconds upon disarming. This wire is used for the Optional Separate Driver’s/Passenger Unlock feature. Connects to unlock circuit for passenger door or doors. See DOOR LOCK WIRING for special configuration options (pages 13-15).

Orange: (-) Negative Starter Disable/Anti-Grind Output

This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect each half to an Orange wire on the relay socket. This output also turns on with remote start to function as an “Anti Grind” wire to prevent the starter from grinding if you get in your car and turn the key too far after it was remote started. See starter disable diagram on next page.

STARTER DISABLE:

 

IGN. SWITCHED

IGNITION SWITCHED

 

"ON" & HOT THROUGH

 

 

 

 

CRANKING

 

STARTER WIRE

 

CONNECT TO

 

CUT

YELLOW

 

ORANGE WIRE

 

OF ALARM

 

STARTER

 

 

PRE-WIRED

 

 

STARTER DISABLE

BLUE

 

RELAY & SOCKET

ORANGE

MAKE CERTAIN TO

 

ORANGE

 

 

CONNECT BROWN

START OUTPUT

 

WIRE TO STARTER

 

MOTOR SIDE!!!

FROM ALARM

BROWN

 

6-PIN HARNESS

 

 

7

Page 7
Image 7
Fortress Technologies FS-50 manual Orange Negative Starter Disable/Anti-Grind Output