Franke Consumer Products FQD 907 manual Comfort panels, Charcoal filter recycling version

Comfort panels

• Open the comfort panels.

• To unfasten the side panels from the hood casing it is necessa- ry to slide the fixing pivot lever.

• When unfastening the central comfort panel pull it forcefully using both hands.

•It is recommended to use a neutral detergent liquid and a damp cloth when washing the outer surface of the comfort panel.

•Wash the inner part of the panel as well by using a neutral de- tergent liquid and a damp cloth; in any case do not use wet sponges or other clothes nor water jet or corrosive detergents.

Charcoal filter (recycling version)

•This filter cannot be washed or regenerated. It must be replaced when the EF appears on the display or at least once every 4 months.

Activation of the alarm signal

•In the recycling version hoods the filter saturation alarm must be activated during the instal- lation or later.

•Switch off the hood and the lights.

•Disconnect the hood from the mains supply.

•When restoring the connection press and hold B-key.

•When releasing the key two rotating rectangles appear on the display.

•Within 3 seconds press the B-key until a flashing confirmation appears on the dispaly:

•2 flashes with EF - charcoal filter saturation alarm ACTIVATED

•1 flash with EF - charcoal filter saturation alarm DEACTIVATED.

REPLACING THE CHARCOAL FILTER
Reset of the alarm signal
•	Switch off the hood and the lighting. If the 24h-function has	B
•	been activated this has to be deactivated.		A
	Press the E-key until the display is unlit.

Replacing of the filter

•Open the comfort panels pulling them downwards.

•Remove the metal grease filters.

•Remove the saturated charcoal filter by releasing the fixing hooks

•Fit the new filter and fasten it in its correct position.

•Put the metal grease filters in their seats.

•Close the comfort panels.

EN	2
	23