Franke Consumer Products FTC 922 Installation, Drilling the Support surface and Fitting the Hood

INSTALLATION

Drilling the Support surface and Fitting the Hood

•The Hood can be fitted directly on the lower surface of the Wall Units (650 mm min. above the Cooker Top) using the snap- on Side Supports.

•Make an opening on the lower surface of the Wall Unit, as indicated. (fig.1)

•Choose the correct flange measure basing on the air outlet diameter and insert it to the upper air outlet opening. (fig.2)

•Screw the closing profile 20 onto the rear part of the hood, using the screws 12f (2.9 x 9.5) provided. (fig.3)

•Open the sliding suction panel.

•Remove the metal grease filters one by one by turning the hooks provided.

•Close the sliding suction panel again.

•Insert the Hood until the snap-on side sup- ports click into place. (fig.4)

•Open the sliding suction panel.

•Lock in position by tightening the screws Vf from underneath the Hood. (fig.4)

•If necessary, adjust the whole filter holder unit and proceed as follows:

•Loosen the four adjustment screws Vr and close the sliding panel again. (fig.5)

•Move the entire filter holder unit until it is properly aligned with the wall unit. (fig.6)

•Keeping the hood canopy still, remove the sliding panel and lock the adjustment screws again. (fig.5)

•The hood can now be fastened to the wall unit using the four screws 12a (3.5 x 16) provided. (fig.7)

1

	10
162	2

523

3

4

Vr

5

6

12a

7

•Replace the metal grease filters.

•Close the sliding suction panel again.

EN	1
	15