American Power Conversion 60kW InfraStruXureTM System

Installation Procedures: Connect the Power Source to the PDU

InfraStruXure System—Installation and Start-Up 15

– In the top of the PDU for overhead wiring

2. Cut an appropriately-sized hole in the gland plate for the conduit.

3. Re-attach the gland plate.

4. Install a lock-nut and bushing to the conduit.

5. Thread the conduit through the hole.

Contents

Main Page About this Manual Page Contents Safety ......................................................................1 Site Planning............................................................5 Installation Procedures ...........................................13 Start-Up Procedure ................................................ 33 Page Page Safety Overview Cross-refe rence symbols used in this ma nual Save these instructions Safety symbols used in this manual War ni ng s Receiving/moving Installation/Maintenance Maintenance performed while the PDU is receiving input power Total Power Off Emergency Power Off (EPO) EMI Page Site Planning Dimensions NetShelter VX Enclosure InfraStruXure PDU Space Considerations Weight Considerations Heat Output Electrical Requirements and Specifications Procedures requiring a licensed electrician Electrical requirements Emergency Power Off (EPO) PDU Switch UPS Basic Installation Procedure Page Installation Procedures Level the PDU and NetShelter Enclosures Page Page Install a circuit breaker Route the input conductors to the Main Input circuit breaker (or switch) Torque specs and tools required Connect input conductors GL1 GEC L3 L2 L2 Connect an Emergency Power Off Switch Installation Procedures: Connect an Emergency Power Off Switch Connect an EPO switch to the user connection plate and test the switch Contact ClosureNormally Closed ) 24VAC/VDCNormally Open Note Page Safety warnings Connect User Input Contacts and Relay Outputs to the User Connection Plate How to connect contacts to the PDU Monitoring Unit Install Shielding Troughs, Shielding Partitions, and Cable Ladders Shielding Troughs and Shielding Partitions for overhead wiring along rows Cable Ladders for overhead wiring across rows Install InfraStruXure Rack-Mount Devices Install the Rack Automatic Transfer Switches (ATS) Install the Rack Power Distribution Units (PDU) Install the InfraStruXure Manager and Hub (or Switch) Install the Environmental Monitoring Unit or Environmental Management System Route and Attach Overhead Wiring Route and attach power cables to equipment racks Page Page Wiring Under the Floor N G Route Data Cables to the InfraStruXure Manager Hub (or Switch) Start-Up Procedure Safety warnings Ensure that all power is off Apply power to the system Page Configure the InfraStruXure Manager Appendix A: Operation How to Apply Power to the System Page Page Page Appendix B: Changes in This Manual Page Index A C E I T U W Page Page Page Page Page Page Page *990-1638B* APC Worldwide Customer Support 990-1638B 06/2004