Franklin SDK-763, SDK-765 manual Installing Batteries, Installing Book Cards

Models: SDK-763 SDK-765

1 78
Download 78 pages 16.3 Kb
Page 9
Image 9
Installing Batteries

Installing Batteries

Installing Book Cards

 

 

 

Your BOOKMAN model is powered by two AAA, 1.5-volt batteries. Here is how to install or replace them.

1.Turn your BOOKMAN over.

2.Remove the battery cover on the back of your BOOKMAN by compressing its tab with your finger and then lifting the cover.

3.Install the batteries as shown on the diagram in the battery compartment.

4.Replace the battery cover.

When the Batteries Are Low

An on-screen warning message will appear when the batteries in your BOOKMAN Sidekick are low on power. This message does not mean that any of the information en- tered in your BOOKMAN Sidekick is in danger of being lost or erased. However, you may not be able to create new entries until fresh batteries are installed.

Warning: Never install or remove a book card when your BOOKMAN is turned on. If you do, information that you entered in any installed book cards may be erased. However, information saved in your BOOKMAN Sidekick will not be erased.

1.Turn your BOOKMAN off.

2.Turn your BOOKMAN over.

3.Align the book card tabs with the notches in a card slot.

4.Press the book card until it snaps into place.

Removing Book Cards

Warning: When you remove most book cards, information that you en- tered is not saved in the book cards. If you change the batteries or reset your BOOKMAN, that information will be erased.

8

Page 9
Image 9
Franklin SDK-763, SDK-765 manual Installing Batteries, Installing Book Cards