Figure 21. Drill pilot holes and/or sink wall anchors at the 5 marked locations.
5Set the wall bracket aside. Using a 1/8" bit, drill a pilot hole at all five points marked in the previous steps.
If a pilot hole hits a stud during this step, DO NOT WIDEN that pilot hole or install a wall anchor at that location.
If a pilot hole does not hit a stud, use a 1/4" bit to widen that pilot hole and using a Phillips screwdriver install a wall anchor so that it is flush with the wall (see figure 21).
Figure 22. Using a level, square the wall bracket and install the screws.
6Mount the wall bracket to the center wall anchor (or pilot hole) using a 1" Phillips head screw driven through the wall brackets center point. Do not fully tighten the
7Using a level, square the bracket and drive the four remaining 1" Phillips head screws into the wall anchors (or pilot holes). Do not fully tighten the screws (see figure 22).
8Using a level, make sure the bracket is level and tighten all five screws (see figure 22).
Mounting the Fresco i On A Wall or Ceiling 11