Installing the Fresco i
Required hardware (included):
(5) wall anchors
(5) 1" Phillips head wood screws
Required tools (included): 6mm Allen tool
Required tools (not included):
Level
Electric drill and 1/4" and 1/8" drill bits
Phillips screwdriver
1Hold the Fresco i at the mounting location. Examine the location to assure the wall is free of obstructions.
Test the direction of rotation to assure that the speaker can rotate toward your listening position. If the speaker rotates away from your listening position, please refer to 'Which Direction Should It Rotate?' (page 5) and ‘ Changing the Direction of Rotation’ (page 7).
2NOTE: These instructions describe the position of the wall bracket with the Fresco i mounted flush against a wall (not rotated on its bracket).
NOTE: The center point of the
Determine where the center point of the wall bracket should be marked (see figures 16 and 17).
Will the Fresco i remain flat against the wall? If so, it can be installed flush against an object such as a plasma screen (see figure18).
Will the Fresco i be rotated to point towards the listening position? If so you need to leave space between the nearest object to allow clearance for the speaker to pivot (see figure 18). At least 6.75
”(17.2cm) of clearance will allow the Fresco i to pivot within its full range of motion. Less space is needed if the Fresco i does not need to fully rotate. As recommended above, before drilling any holes, hold the Fresco i at its desired location and rotate it into place to assure you have adequate clearance.
Counter |
|
Clockwise | Clockwise |
Rotation | Rotation |
Figure 16. Determining the wall brackets center point in a vertical installation.
Down
Rotation
Up
Rotation
Figure 17. Determining the wall brackets center point in a horizontal
Figure 18. Clearance requirements to allow rotation of the Fresco i.
Mounting the Fresco i On A Wall or Ceiling 9
