Changing the Direction of Rotation
Required tools (included): 2.5mm Allen tool, 6mm Allen tool
NOTE: This procedure can be performed either with the bracket assembly installed on the Fresco i cabinet or with the bracket assembly uninstalled. For the purpose of illustrating this procedure, the bracket assembly is depicted installed on a cabinet.
1Ignore this step if the bracket assembly is not installed on the Fresco i. Prepare a flat surface with padding and sheets to protect the speaker as you work on it. Remove the Fresco i's grill cover and carefully place the Fresco i face down on the work surface, using books or pieces of cardboard to keep the speaker from rocking.
2Using the 6mm Allen tool, remove the 2 cap nuts and washers from the hinges. Place them aside (see figure 7).
3Carefully remove the wall bracket from the cabinet bracket (see figure 8).
4Using the 2.5mm Allen tool, carefully remove the 2 set screws that hold the 2 hinge pins in place (see figure 9).
5Move the wall bracket hinge pin to the outside of the opposite hinge. Move the cabinet bracket hinge pin to the outside of the opposite hinge (see figure 10).
6Using the 2.5mm Allen tool, reinstall the 2 set screws to lock the hinge pins in place. Make sure the set screw tightens against the flat surface of the pin (see figure 11).
7 Reinstall the washers and cap nuts.
Figure 7. Remove the 2 cap nuts and washers from the hinges.
Figure 8. Remove the wall bracket from the cabinet bracket.
Figure 9. Remove the 2 set screws.
Figure 10. Change hinge pin locations.
Figure 11. Reinstall the two set screws to hold hinge pins in place.
Mounting the Fresco i On A Wall or Ceiling 7
