OPERATION
Signal Connection | On Wall/Off Wall Switch |
Use the best speaker cables you can. The length and type of speaker cable used in your system will have an audible effect. Under no circumstance should a wire of gauge higher (thinner) than #16 be used. In general, the longer the length used, the greater the necessity of a lower gauge, and the lower the gauge, the better the sound.
A variety of speaker cables are now available whose manufacturers claim better performance than standard heavy gauge wire. We have verified this in many cases, and the improvements available are often more noticeable than the differences between wires of different gauge. The effects of cables may be masked if the equipment is not of the highest quality.
Connections are done at the signal input section on the rear electronics panel of the Fresco i (see figure 1). Use spade connectors for optimum contact. Make certain that all of your connections are tight.
Be consistent when connecting speaker leads to the terminals on the back of the Fresco i. Take great care to assign the same color to the (+) terminal on both the speaker and the amplifier.
WARNING! Turn your amplifier off before making or breaking any signal connections!
Fresco i features a unique
Break-In
Due to the sophisticated materials used to create high- resolution ATF™ (Advanced Thin Film) drivers your new speakers require a
Figure 1. Single wire connection. One channel shown.