Friedrich 2008 electrical DATA, HACR Heating Air Conditioning and Refrigeration, Fire Hazard

electrical DATA

WARNING

ELECTRIC SHOCK HAZARD

Turn off electric power before service or installation.

All electrical connections and wiring MUST be installed by a qualified electrician and conform to the National Electrical Code and all local codes which have jurisdiction.

Failure to do so can result in personal injury or death.

	NOTICE
	FIRE HAZARD
	Not following the above WARNING could result in fire or
	electically unsafe conditions which could cause moderate
	or serious property damage.
	Read, understand and follow the above warning.
Wire Size	Use ONLY wiring size recommended for single outlet branch circuit.
Fuse/Circuit Breaker	Use ONLY the correct HACR type and size fuse/circuit breaker. Read electrical ratings on unit’s
	rating plate. Proper circuit protection is the responsibiity of the homeowner.
Grounding	Unit MUST be grounded from branch circuit through service cord to unit, or through separate
	ground wire provided on permanently connected units. Be sure that branch circuit or general
	purpose outlet is grounded.
Receptacle	The field supplied outlet must match plug on service cord and be within reach of service cord.
	Do NOT alter the service cord or plug. Do NOT use an extension cord. Refer to the table above
	for proper receptacle and fuse type.

The consumer - through the AHAM Room Air Conditioner Certification Program - can be certain that the AHAM Certification Seal accurately states the unit’s cooling and heating capacity rating, the amperes and the energy efficiency ratio.

*HACR: Heating Air Conditioning and Refrigeration

10