Friedrich 2009 To adjust temperature, To set the hour clock, To start unit, To set the timer

How to use the remote control* (QuietMaster Programmable)

To start unit

1POWER - Press the Power button once. The unit will automatically turn on in the mode and fan speed it was last left on.

To set mode of operation

2COOL - Press the Cool button to automatically switch the operating mode to COOL.

3FAN ONLY - Press the Fan Only button if you want to run the fan only. You may want to use this feature in conjunction with the Fresh Air/ Exhaust if you want to bring outside air into the room, or exhaust stale air.

4MoneySaver® - Press the MoneySaver® button to activate the MoneySaver® feature. This cycles the fan with the compressor so that the fan does not run all the time.

To set the timer

NOTE: Set the hour clock before attempting to set timer functions. You can set the timer On/Off a minimum of one hour apart, and a maximum of 23 hours apart.

9TIMER START - Press Start to view the current start time for cool- ing. Continue pressing the Start button until you arrive at the start time you desire. The start time for cooling will then be set.

10TIMER STOP - Press the Stop button. Continue pressing the Stop button until you arrive at the stop time you desire. The stop time for cooling will then be set.

11TIMER ON/OFF - Press the On/off button once to activate (light on) or deactivate (light off) the timer. Once the Start and Stop times have been selected, they will remain in memory, and cycle daily until changed.

To adjust temperature

5COOLER - Press the Cooler button to raise the temperature setting.

6WARMER - Press the Warmer button to lower the temperature setting.

To adjust fan speed

7FAN SPEED - Press the Fan Speed button to see the current set- ting. Press again to change the fan speed. F1 is the lowest setting (SLEEP SETTING), F2 is low speed (LOW), F3 is medium (MED), and F4 is high (HIGH).

To set the hour clock

8SET HOUR CLOCK - Press Set Hour once to see the current clock set- ting. Continue pressing the button until you arrive at the current time.

MAKE SURE YOU SET THE A.M. AND P.M. PROPERLY. (NOTE: MINUTES ARE NOT SHOWN ON THE DISPLAY.) A light will appear in the upper left corner of the display when the hour is P.M.

*A Friedrich RC1 wireless remote control can be used to operate all QuietMaster® Programmable models.

NOTE: If the unit is unplugged or the power is interrupted, the HOUR CLOCK must be reset or the Timer On/off functions will not work.

Figure 4
	Temperature
6	Cooler			Warmer	5
2	Cool			Power	1
3	Fan	Fan		Money	4
	Only	Speed		Saver®
	Timer Operation				7
11	On/O￿	Start	Stop	Set Hr.	8
9					10

13