Disassembly Instructions, Mechanical Parts, Front Grille

Figure 1

Figure 2

2.DISASSEMBLY INSTRUCTIONS

ÑBefore the following disassembly, set POWER SWITCH to OFF and disconnect the power cord.

1. Open the lnlet grille downward and remove the air filter.

2. Remove the screw which fastens the front grille.(See Figure 1)

3. Pull the front grille from the right side.

4. Remove the front grille.(There are 4 hooks.)

5. Re-install the components by referring to the removal procedure, above.

1. After disassembling the FRONT GRILLE, remove the 2 screws which fasten the cabinet at both sides.

2.Remove the 2 screws which fasten the cabinet at back.

3. Pull the base pan forward. (See Figure 2)

4. Remove the cabinet.

5. Re-install the components by referring to the removal procedure, above.

1. Remove the front grille. (Refer to section 2.1.1)

2. Remove the cabinet. (Refer to section 2.1.2)

3. Remove the 2 screws which fasten the power cord.

4. Disconnect the grounding screw from the evaporator channel.

5.Remove the 1 screw which fastens the control box cover.

6.Remove the housing which connects PCB(CP 08/10/12) or connector(ZQ 08/10) and motor wire in the control box.

7.Remove the nut which fastens the terminal cover.

8.Remove the terminal cover.

9. Remove all the leads from the overload protector.

10. Discharge the capacitor by placing a 20,000 ohm resistor across the capacitor terminals.

11. Raise the control box upward completely. (See Figure 3)

12. Re-install the components by referring to the removal procedure, above.

(Refer to the circuit diagram found on page 27 in this manual and on the control box.)

Ñ6Ñ