Setting Surface Controls | The surface control knobs | |||||
Each burner lights automatically from an electric ignitor each time a control knob is turned to | shown below may not look iden- | |||||
the lite position. | tical to the Surface Controls | |||||
Knobs on your range; They are | ||||||
To operate the surface burner: | ||||||
only representational. | ||||||
1. | Place cooking utensil on burner. |
|
|
|
| |
|
|
|
| |||
2. | Push in and turn the Surface Control knob to LITE. Note: All electronic ignitors will click |
|
|
|
| |
| at the same time. However, only the burner you are turning on will ignite. |
|
|
|
| |
|
|
|
|
| ||
3. | Visually check that the burner has lit. |
|
|
|
| |
4. | After the burner lights, turn the control knob to the desired flame size. The control knobs |
|
|
|
| |
|
|
|
| |||
|
|
|
| |||
| do not have to be set at a particular mark. Use the guides and adjust the flame as needed. |
|
|
|
| |
|
|
|
|
| ||
|
|
|
|
| ||
| DO NOT cook with the control knob in the LITE position. (The electronic ignitor will |
|
|
|
| |
| continue to click if left in the LITE position.) |
|
|
|
| |
5. | To turn the burner off, turn the control knob as far as it ill go, to the OFF position. |
|
|
|
| |
|
|
|
| |||
In the event of an electrical power outage, the surface burners can be lit manually. To light a
surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to LITE. Use caution when lighting surface burners manually.
Surface burner in use when an electrical power failure occurs will continue to operate normally.
Do not operate the burner for an extended period of time without cookware on the grate. The finish on
the grate may chip without cookware to absorb the heat.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the cooktop when it is in use. These items could melt or ignite. Pot holders, towels or wood spoons could catch fire if placed too close to a flame.
Before Setting Oven Controls
Oven Vent Location
The oven is vented at the rear of the cooktop. When the oven is on, warm air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT block the vents. Doing so may cause cooking failures, fire or damage to the appliance
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING
THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out.
To replace an oven rack, Fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Setting Oven Controls
For oven settings, refer to the time or the electronic oven control section.
8
