Frigidaire 318200869 Avoid Transportation Damage to your Range, SELF CLEANING OVEN some models

Avoid Service Checklist (continued)

PROBLEM	POSSIBLE CAUSE/SOLUTION
SELF CLEANING OVEN (some models)
Self-cleaning cycle does not work.	Control(s) not set properly. Follow instructions under Oven Cleaning in the Electronic Oven
	Control section.
	Self-cleaning cycle was interrupted. Stop time must be set 3 to 4 hours past the start time.
	Follow steps under To Stop or Interrupt a Self-Cleaning Cycle in the Electronic Oven
	Control section
Soil not completely removed after	Failure to clean bottom, front top of oven, frame or door area outside oven seal. These
self-cleaning cycle.	areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these
	areas before the self-cleaning cycle is started. Burned-on residue can be cleaned with a stiff
	nylon brush and water or nylon scrubber. Be careful not to damage the oven seal.

Avoid Transportation Damage to your Range

If you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take the following precautions:

1.Screw in the levelling legs under the range.

2.Remove the racks and other utensils from the oven, and from the lower drawer.

3.Use adhesive tape to firmly secure the door and the drawer to the side panels. Also attach the electric power cord in the same manner.

4.Use a two-wheeled trolley with strap and fasten the range to it. Cover the appliance with a heavy blanket to prevent scratches and dents.

5.Avoid pulling or pushing the control panel when moving the appliance.

23