Frymaster 8196606 manual Readdressing the Cabinet

Cabinet Service Procedures

Readdressing the Cabinet

Addressing, or assigning a position-specific component such as a display or distribution board, is done automatically by the cabinet on startup. Communication errors can occur on start-up after a board installation however. If so, follow the instructions below to readdress the cabinet. This process can also be used during troubleshooting when displays are connected out of synch with their associated bezel on the same row level.

1.Press the programming key.

2.Enter 1111 at the Enter Access Sequence prompt.

3.The screen will scroll Row 1 Top Heater Off.

4.Scroll with X through all the Heater Plate prompts until the screen displays Press OK to Re- Address.

5.Press OK.

6.Screen Displays Please Power Cycle Off.

7.Turn the cabinet off and back on.

8.The cabinet will start in the normal start-up sequence.

2-5