CF SERIES GAS FRYERS
CHAPTER 2: INSTALLATION INSTRUCTIONS
Gas Connection Pipe Sizes
[Minimum incoming pipe size should be
|
|
|
|
| 4 or more |
|
|
| |
|
| Gas | Single Unit | 2 - 3 Units | units* |
|
|
| |
|
| Natural | 3/4" (19 mm) | 1" (25 mm) | (33 mm) |
|
|
| |
|
| Propane | 1/2" (13 mm) | 3/4" (19 mm) | 1" (25 mm) |
|
|
| |
|
| Manufactured | 1" (25 mm) | (38 mm) |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
*For distances of more than 20 feet (6 m) and/or more than four fittings or elbows, increase the connection by one pipe size.
CE Standard
CE regulations require a combustion air supply of 2m3/h per kW per fryer. (See rating plate affixed to door for kW rating.)
1.Connect the
NOTE: Some fryers are configured for a rigid connection to the gas supply line. These units are connected to the gas supply line at the rear of the unit.
When using thread compound, use very small amounts on male threads only. Use a pipe thread compound that is not affected by the chemical action of LP gases (Loctite PST567 sealant is one such compound). DO NOT apply compound to the first two threads. Applying compound to the first two threads will cause clogging of the burner orifices and control valve.
2.Open the
DANGER
All connections must be sealed with a joint compound suitable for the gas being used and all connections must be tested with a solution of soapy water before lighting any pilots.
Never use matches, candles, or any other ignition source to check for leaks. If gas odors are detected, shut off the gas supply to the appliance at the main
