Frymaster FMCF or the transfer is very, slow. cont, Power Shower is not, spraying properly

CF SERIES GAS FRYERS

CHAPTER 6: OPERATOR TROUBLESHOOTING

6.4 Troubleshooting the Built-In Filtration System (cont.)

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
	B. Improperly installed or prepared
	filter pan components.	B. Remove the oil from the filter pan
	Test: Close the drain valve.	and replace the filter paper,
		ensuring that the filter paper
	Move the filter handle to the OFF
		support screen is in place under
	position, pull the filter pan (and
		the paper.
	Power Shower, if so equipped)
	from the unit. Move the filter	If this does not correct the
	handle to the ON position.
		problem, the filter tube suction
Pump starts, but no	If a strong stream of air is being	tube is probably blocked. Remove
		the blockage using a thin, flexible
transfer takes place	pumped out of the oil return port
		wire. If unable to remove the
or the transfer is very	(or the Power Shower port), the
		blockage, call FASC.
slow. (cont.)	problem is with the filter pan
	components.
		C. Verify that filter connection
		O-rings are present and in good
	C. Improperly installed or prepared	condition.
	filter pan components.	Replace the filter paper, ensuring
		that the filter paper support screen
		is properly positioned under the
		paper.
	A. Plugged openings or solidified
	shortening in the Power Shower.	A. Clean the Power Shower per
	Test: Look for oil squirting out	instructions in Chapter 5 of this
		manual.
	around the Power Shower gasket.
Power Shower is not	If so, Power Shower is obstructed.
	B. Missing/worn O-rings and gasket	B. Verify that O-rings and gasket are
spraying properly.	on Power Shower.	present and in good condition.
	C. Missing paper in filter pan. (This
	causes too much pressure in the
	oil return lines, resulting in a	C. Verify that filter paper is properly
	strong flow through the Power	installed in the filter pan.
	Shower, but also squirting of oil
	from around the gasket.)

6-6