Frymaster FMCF operation manual Replacing the Controller or Controller Wiring Harness

CF SERIES GAS FRYERS

CHAPTER 6: OPERATOR TROUBLESHOOTING

6.6 Replacing the Controller or Controller Wiring Harness

1.Disconnect the fryer from the electrical supply.

2.The controller bezel is held in place by tabs at the top and bottom. Slide the bezel up to disengage the lower tabs. The slide the bezel down to disengage the upper tabs.

3.Remove the two screws in the upper corners of the control panel and swing the panel open from the top, allowing it to rest on its hinge tabs.

4.Disconnect the wiring harness from the back of the controller and, if replacing the harness, disconnect it from the interface board (arrows).

5.If replacing the controller, disconnect the ground wire and the 15-pin connector (arrows), and then remove the controller by lifting it up and out from the hinge slots in the control panel frame.

6.Reverse the procedure to install a new controller or wiring harness.

If replacing harness, disconnect the harness from the controller and interface board (arrows).

If replacing controller, disconnect the ground wire and the 15-pin connector (arrows).

6-8