g. Go to step 9.3.2 and reassemble the air delivery tower.
9.7 Accessing the Plate and Air Heaters:
a. Use the following method to remove the plate heater assembly or access the compartment underneath the plate
heater.
b. Remove the cowl assembly per steps | After cutting the acrylic adhesive between the | ||||||
| 9.3. |
|
| ||||
|
|
| heater plate and the HLZ chassis, use a | ||||
c. | Then remove the air delivery assembly | screwdriver to gently lift the heater plate. | |||||
|
|
|
| ||||
| following steps in 9.5. |
|
|
|
|
|
|
d. | Insert a thin, sharp knife, i.e. |
|
|
|
|
| |
|
|
|
|
|
| ||
| plate and the HLZ chassis. |
|
|
|
|
| |
| Carefully cut the silicon adhesive |
|
|
|
|
| |
| between the heater plate and the |
|
|
|
|
| |
| chassis. |
| Gently lift the heater plate, which may still be stuck to | ||||
|
|
| |||||
e. | Lift the heater plate by prying | up | the adhesive. Apply new acrylic tape to the chassis | ||||
| one end of the heater plate away | before reinstalling the heater plate. | |||||
|
|
|
|
|
| ||
| from the HLZ chassis. The plate is |
|
|
|
|
| |
| held in place by an acrylic tape. It will be difficult to | NOTE: A hot platen is |
| ||||
| break the bond between the | heater | plate | and | easier to remove. The |
| |
| chassis. |
|
|
|
| heat makes the |
|
f. | Remove acrylic tape from the heater | plate | and | adhesive holding the |
| ||
platen in place more |
| ||||||
| frame to prevent rebounding while servicing. |
|
| ||||
|
| pliable. |
| ||||
|
|
|
|
|
|
| |
g. | When reinstalling the heater plate, apply new |
|
| ||||
|
| ||||||
| acrylic tape to the HLZ chassis first. Then position the heater plate standing on |
its side against the back air delivery assembly. The heater plate leads should be coming off the “top” edge of the heater plate.
h.Once the heater plate is aligned properly with the HLZ chassis, gently lower the heater plate until the plate end with the lead wires is approximately 2 inches from the chassis. Feed the leads through the opening in the chassis wall.
i.Finish lowering the heater plate into place and connect the heater plate lead wires.
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana
Printed in the United States | Service Hotline | Page 12 |
|
|