Frymaster HLZ 22, HLZ 18 service manual Operation

Display reads SET,		and	LED’s light.
Press	to program the heater plate or			to
program the air heater.

Press the Up and Down Arrow Keys to achieve the desired set-point temperature, then press the Check Switch once. Both heater LEDs will again light.

Press or to get desired setpoint, then press

to lock the temperature in.

If you are finished with programming both heaters, press the Check Switch again to store the programmed setpoints and exit the programming mode OR to change the setpoint temperature for the other heater, press the corresponding Heater Switch (1 or 4). Program as described in Step 4.

When finished, press again to exit programming

mode. To change the other heater, press to

program the heater plate or to program the air

heater, then go to Step 4 for instructions.

7.2 Operation

1.Press the ON/OFF switch to the ON position (the display will light and cycle through an initialization sequence). The display will read –LO- until the air heater and heater plate are within 15°F of setpoint. It will take approximately 10 minutes for the HLZ to achieve

operating temperature.

Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000

318-865-1711 FAX 318-862-2394

Printed in the United States	Service Hotline	Page 6
	1-800-24-FRYER