9.8 Replacing Hi-limit
a.Follow steps in Accessing plate and air heaters, 9.7.
b.Remove the shield over the air heater
c.Remove the brace on the left side of the base assembly, exposing the wire raceway.
d.Remove the grommets the
e.Remove the existing
f.Mount the
g.Push the wires through the raceway toward the transformer on the controller side of the HLZ.
h.Slip the wires from the
i.Slip the
j.Plug the black wire leading from pin 1 in the computer plug into the terminal of the
k.Plug the other
l.Ensure all connections are tight.
m.Retie the wiring assembly
n.Replace the brace, which forms the wire raceway.
o.Replace the metal shield over the air heater.
The wires for the
The wire is routed from the air cowling, through the raceway, emerging at the transformer.
p.Clear away the old adhesive holding the heater plate in place.
q.Put the
r.Ensure the heater plate’s ground wire is reconnected.
s.Plug the
t.Reassemble unit as described in step 9.9 below.
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana
Printed in the United States | Service Hotline | Page 13 |
|
|