Frymaster BIRE14, MRE14 Continued on, following page, Problem, Probable Causes, Corrective Action

Models: BIRE14 MRE14

1 32
Download 32 pages 14.43 Kb
Page 29
Image 29

6.2.3 Filtration Problems

Problem

Probable Causes

Corrective Action

 

 

A. Verify that the power cord is

 

A. Power cord is not plugged in or

fully plugged in. If so, verify

 

circuit breaker is tripped.

that circuit breaker is not

 

 

tripped.

 

 

B. If the motor is too hot to touch

 

 

for more than a few seconds, the

 

B. Pump motor has overheated

thermal overload switch has

 

causing the thermal overload

probably tripped. Allow the

Filter pump won't

switch to trip.

motor to cool at least 45

 

minutes then press the Pump

start.

 

 

Reset Switch.

 

 

 

C. Blockage in filter pump.

C. Pump blockages are usually

 

Test: Close the drain valve and

caused by sediment buildup in

 

the pump due to improperly

 

pull the filter pan out from the

sized or installed filter

 

fryer. Activate the pump. If the

components and failure to use

 

pump motor hums for a short time

the crumb screen. Call FASC.

 

then stops, the probable cause is

 

 

blockage of the pump itself.

 

Filter pump runs

Blockage in filter pan suction tube.

The blockage may be caused by

Test: Close the drain valve and pull

sediment buildup or, if solid

but oil does not

shortening is used, solidified

return to frypot and

the filter pan out from the fryer.

shortening in the tube. Use a thin,

there is no bubbling

Activate the pump. If bubbling

flexible wire to remove the

oil.

occurs, there is a blockage in the

blockage. If the blockage cannot

 

filter pan suction tube.

be removed, call FASC.

 

 

A. If using filter paper or pad

 

 

configuration, verify that filter

 

 

screen is in bottom of pan with

 

 

paper or pad on top of screen.

 

 

Verify if using a pad that the

 

 

rough side is facing up.

Filter pump runs,

A. Improperly installed filter pan

Verify that O-rings are present

but oil return is very

components.

and in good condition on filter

slow.

 

 

pan connection fitting.

 

 

 

 

If using Magnasol filter

 

 

assembly, verify that O-ring is

 

 

present and in good condition on

 

 

filter screen fitting.

 

Continued on

following page.

6-6

Page 29
Image 29
Frymaster BIRE14, MRE14 warranty Continued on, following page, Problem, Probable Causes, Corrective Action