3.2.2 Setting Documents
This section explains how to set documents.
Loosening documents
Before setting documents, sufficiently loosen them by the following procedure:
·Remove a 4 mm thick section of pages, hold the ends of the documents with both hands, and bend the documents.
·Hold the documents strongly with both hands so that both ends of the documents are slanted, and then unbend the documents so that they are inflated.
·Repeat the operations described above two or three times.
·Turn the document by 90o and similarly loosen it.
uKey point
The thickness of the documents to be set shall be 4 mm or less. Failure to do so could result in the paper jam or the reading defect.
Leveling both ends and setting the documents
Level both ends of the documents so that they can be read correctly.
uKey point
Set the documents as follows:
For
For
|
