Manuals
/
Fujitsu
/
Computer Equipment
/
Modem
Fujitsu
FC9660RA12 manual
Models:
FC9660RA12
1
1
25
25
Download
25 pages
13.33 Kb
1
2
3
4
5
6
7
8
<
>
DSL Modem Turn-up Flow Chart
Safety
Power
Connector
Page 1
Image 1
Page 2
Page 1
Image 1
Page 2
Contents
Page
FJTU-320-600-900
DSL Modem Installation Guide Issue 2, Rev 2, February
Safety Warnings
Safety Information
UL Installation Safety Instructions
FCC Warning
Page
Page
Table of Contents
3 Installing the Splitterless DSL Modem
4 Installing the DSL Modem with Splitter
Page
1.1 ADSL Technology
1 Introduction
1.2 Unpacking Instructions
Power Supply Convertor
1.3 DSL Modem Package Contents
Figure 1-1 DSL Modem Package Contents
DSL Modem
2.1 DSL Front Panel
2 DSL Modem Description
POWER
Indicates power is applied to the modem
Connector
2.2 DSL Rear Panel
POWER
Multipin connection for the power supply wall transformer
Figure 2-3 shows the bottom of the DSL modem
2.3 DSL Bottom Panel
Figure 2-3 DSL Bottom Panel of Modem
m0435.fh82
3.1 Overview
3 Installing the Splitterless DSL Modem
Figure 3-1 Typical Splitterless Installation
3.2 Microfilter Installation Procedures
Figure 3-3 Answering Machine Application
Figure 3-2 Telephone Set Application
Figure 3-4 Fax Application
Phone Jack
Microfilter
Figure 3-5 Ethernet Cable Connection
Figure 3-6 Multi-User Ethernet Internet Access
4.1 Connecting the Inside Wire and Modem Cables
4 Installing the DSL Modem with Splitter
Figure 4-1 Connecting Inside Wire and Modem Cables
Telephone Network Interface Box
Figure 4-2 Telephone Network Interface Box- DSL Splitter
2. Inside the residence, locate the telephone RJ-11 wall jack that is nearest to your PC and remove it. Replace it with a new dual RJ-11 wall plate and connect the same colored wires that are attached to the green and red screws on the DSL splitter data module to the green and red pins on the RJ-11 wall jack. For example, if a black wire is connected to the green screw in the data side of the DSL splitter see Figure 4-2 , connect the same black wire to the green pin of the new wall jack. If required, repeat this step for the voice wire
Figure 4-3 Multi-User Speedport Internet Access
5 Powering the Modem
DSL Modem Turn-up Flow Chart
Figure 5-1 Turn-Up Flow Chart
