Fujitsu FC9660RA12 manual Microfilter Installation Procedures, 1 Typical Splitterless Installation

3.2 Microfilter Installation Procedures

Installing microfilters should not require any new inside wiring. Existing wired RJ-11 telephone jacks are all that is required to complete this installation. See Figure 3-1for an installation diagram.

RJ-11

Phone 2-Outlet

Jack Modular

Adapter

RJ-11 Line Cord

FC9660CB26

LINE PHONE

Microfilter

DATA

LINE	DSL Modem
	FC9660RA12
Line

Telephone

m1227.fh8_4

Figure 3-1: Typical Splitterless Installation

1.Start in the location where you want to install your DSL modem. Look for the existing phone outlet (RJ-11 faceplate), and remove the existing RJ-11 cord from the wall.

2.Connect the provided two-outlet modular adapter device into the RJ-11 telephone jack.

3.Connect the provided DSL modem RJ-11 line cord, part number FC9660CB26, into one side of the two-outlet modular adapter.

4.Connect the other end into the RJ-11 LINE slot, located on the back of DSL modem.

5.Connect one of the provided microfilters into the remaining empty two-outlet modular adapter slot.

8