Manuals
/
Fujitsu
/
Computer Equipment
/
Modem
Fujitsu
FC9660RA12 manual
Models:
FC9660RA12
1
6
25
25
Download
25 pages
13.33 Kb
3
4
5
6
7
8
9
10
<
>
DSL Modem Turn-up Flow Chart
Safety
Power
Connector
Page 6
Image 6
Page 5
Page 7
Page 6
Image 6
Page 5
Page 7
Contents
Page
DSL Modem Installation Guide Issue 2, Rev 2, February
FJTU-320-600-900
UL Installation Safety Instructions
Safety Information
Safety Warnings
FCC Warning
Page
3 Installing the Splitterless DSL Modem
Table of Contents
Page
4 Installing the DSL Modem with Splitter
Page
1 Introduction
1.1 ADSL Technology
1.2 Unpacking Instructions
Figure 1-1 DSL Modem Package Contents
1.3 DSL Modem Package Contents
Power Supply Convertor
DSL Modem
POWER
2 DSL Modem Description
2.1 DSL Front Panel
Indicates power is applied to the modem
POWER
2.2 DSL Rear Panel
Connector
Multipin connection for the power supply wall transformer
Figure 2-3 DSL Bottom Panel of Modem
2.3 DSL Bottom Panel
Figure 2-3 shows the bottom of the DSL modem
m0435.fh82
3 Installing the Splitterless DSL Modem
3.1 Overview
3.2 Microfilter Installation Procedures
Figure 3-1 Typical Splitterless Installation
Figure 3-4 Fax Application
Figure 3-2 Telephone Set Application
Figure 3-3 Answering Machine Application
Phone Jack
Figure 3-5 Ethernet Cable Connection
Microfilter
Figure 3-6 Multi-User Ethernet Internet Access
4 Installing the DSL Modem with Splitter
4.1 Connecting the Inside Wire and Modem Cables
Figure 4-1 Connecting Inside Wire and Modem Cables
Figure 4-2 Telephone Network Interface Box- DSL Splitter
Telephone Network Interface Box
2. Inside the residence, locate the telephone RJ-11 wall jack that is nearest to your PC and remove it. Replace it with a new dual RJ-11 wall plate and connect the same colored wires that are attached to the green and red screws on the DSL splitter data module to the green and red pins on the RJ-11 wall jack. For example, if a black wire is connected to the green screw in the data side of the DSL splitter see Figure 4-2 , connect the same black wire to the green pin of the new wall jack. If required, repeat this step for the voice wire
Figure 4-3 Multi-User Speedport Internet Access
5 Powering the Modem
Figure 5-1 Turn-Up Flow Chart
DSL Modem Turn-up Flow Chart
