2.2Connecting the Scanner to Your PC
When running Windows 95 or Windows NT 4.0, connect the SCSI interface cable. When running Windows 98, Windows Me, Windows 2000, or Windows XP, connect either the USB interface cable or the SCSI interface cable.
| Connect only one of the USB or SCSI |
ATTENTION | interface cables. Windows 95 and |
| Windows NT 4.0 do not support USB |
| interface. |
1.Connect the USB interface cable to the USB interface connector.
2.Connect the other end of the USB interface cable to the PC.
•Be sure to use the USB cable which
ATTENTION
comes as an accessory with this scanner.
Correct operation with commercially available cables is not guaranteed.
•When connecting to an USB hub, use the first stage USB hub that is closest to the computer. If you use the second or later hub stages, the scanner may not operate correctly.
•This scanner is provided with two interfaces: Ultra SCSI and USB 1.1. On this scanner, each of the SCSI and USB interface is controlled not to be used simultaneously. Scanner can be only connected to either USB or SCSI interface.
When using the scanner with SCSI interface, a commercially available SCSI interface cable and SCSI card must be purchased.
•SCSI interface cable:
Use a connector which complies with Ultra SCSI. A 50 Pin Contact Shielded
•SCSI card:
Find the recommended SCSI card information in the Fujitsu web site (FAQ). http://imagescanner.fujitsu.com/
•When connecting the SCSI interface
ATTENTION
cable, turn the scanner off. Be sure to first connect the SCSI interface cable and, then turn on the power of the scanner and the personal com- puter.
•In a SCSI daisy chain formation, connect the scanner so that it is the terminated device.
1.Insert the SCSI interface cable into the inter- face connector until both sides click.
2.Connect the other end of the cable to the per- sonal computer.
Be careful not to bend the pins of the
ATTENTIONSCSI cable when connecting to the 
scanner .
| 4 | |
|