2.2Connecting the Scanner to Your PC
When running Windows 95 or Windows NT 4.0, connect the SCSI interface cable. When running Windows 98, Windows Me, Windows 2000, or Windows XP, connect either the USB interface cable or the SCSI interface cable.
When using the scanner with SCSI interface, a commercially available SCSI interface cable and SCSI card must be purchased in addition.
• | SCSI interface cable: |
| Use a connector which complies with Ultra |
| SCSI. A 50 Pin Contact Shielded |
| SCSI Device Connector is required. |
• | SCSI card: |
ATTENTION
This scanner is provided with two inter- faces: Ultra SCSI and USB 2.0 /1.1. Connect only one of the USB or SCSI interface cable. Windows 95 and Windows NT 4.0 do not support USB interface.
| Find the recommended SCSI card information in |
| the Fujitsu web site (FAQ). |
| http://imagescanner.fujitsu.com/ |
•Be sure to use the USB cable which
ATTENTION
comes as an accessory with this scan- ner.
Scanning operation with commercially available cables is not guaranteed.
•When connecting the SCSI interface
ATTENTION
cable, turn the scanner off. Be sure to first connect the SCSI interface cable and, then turn on the power of the scanner and the personal computer.
•In a SCSI daisy chain formation, con- nect the scanner so that it is the termi- nated device.
1.Insert the SCSI interface cable into the inter- face connector until both sides click.
2.Connect the other end of the cable to the per- sonal computer.•When connecting to an USB hub, use the first stage USB hub that is closest to the computer. If you use the second or later hub stages, the scanner may not operate correctly.
•If you connect the scanner with USB 2.0, it is required that the USB port and Hub are compliant with USB 2.0. The scan- ning speed may slow down if it is con- nected with USB1.1.
ATTENTION
Be careful not to bend the pins of the SCSI cable when connecting to the scanner .
4