In addition, when the [ServerSelection] switch on the left side of the front panel, the [AutoScan] switch, and the [RESET] switch are pressed at the same time, various settings are initialized as shown by the following table.
Server name | Initialized |
AutoScan frequency | Initialized |
Normal display status | Initialized |
Setting for whether to display when AutoScan is being performed | Initialized |
| (display is enabled) |
HOTKEY settings | Initialized |
Country code setting | Settings retained |
POWER SUPPLY:ALWAYS ON | Settings retained |
EDID | Settings retained |
Settings retained |
(5)Ports for server connection
The ports of a KVM Switch are connected to the keyboard/mouse/monitor connectors by using dedicated cables.
(6)Monitor connector
The monitor connector is used to connect the monitor to a KVM Switch.
(7)Keyboard connector
The keyboard connector is used to connect the PS/2 keyboard to a KVM Switch.
(8)Mouse connector
The mouse connector is used to connect the PS/2 mouse to a KVM Switch.
(9)USB keyboard/mouse connector
The USB keyboard/mouse connector is used to connect a USB keyboard, mouse, or hub to a KVM Switch.
It does not matter which of these is connected for operation.
Devices other than a USB keyboard, mouse, or hub cannot be connected. The maximum number of devices that can be connected is as follows.
4 port type | Keyboards: 2 |
8 port type | Mouse devices: 3 |
| Hubs: 1 |
16 port type | Maximum total number of keyboards and mouse |
| devices: 4 |
| Maximum number of hubs:1 level |
Note that when wireless type devices are connected using a wireless receiver, a signal may be output that a mouse or keyboard is connected even though a keyboard or mouse is not actually connected.
10