
11. KVM Switch Operation
Point Perform the EDID settings first.
When a monitor is connected to a KVM Switch for the first time, the Plug and Play data (EDID data) must be set. After performing the EDID data settings, the connected monitor can be used in a suitable environment by restarting the server. In addition, because the set EDID data is emulated for all of the ports, even if a server is started without any selected ports, the connected monitor can still be used in a suitable environment.
For details about EDID settings, refer to
11-1. Customer Mode Settings
11-1-1. Hotkey Mode Settings
The following two modes are available for the Hotkey mode. The Hotkey mode can also be turned OFF.
The operations listed in the following table change the mode to the Hotkey mode and display the OSD screen.
| Operation | Hotkey mode default value |
(1) | <Ctrl> + <Alt> + <Shift> are pressed at the | |
same time |
| |
(2) | <CTRL> is pressed twice in succession | |
(3) | <ScrollLock> is pressed twice in | |
succession |
| |
|
|
|
(4) | The central mouse button is pressed | OFF |
If <N> or the right button is pressed in
The mouse can also be used to set the mode.
*Note. Although the mode can be set relatively freely (for example,
*Note. To display the OSD screen, video signal input from at least one connected server is required. If the video signal cannot be input from a server due to settings such as the
23