Fujitsu MAE3091LC, MAF3364LP, MAF3364LC, MAG3182LC, MAE3182LC manual Standard Features

1.1Standard Features

(1)Compactness

Since the SCSI controller circuit is embedded in the standard 3.5-inch fixed disk drive form factor, the IDD is extremely compact. The IDD can be connected directly to the SCSI bus of the host system .

(2)SCSI/CCS standard

The IDD provides not only SCSI basic functions but also the following features:

∙Arbitration

∙Disconnection/reselection

∙Data bus parity

∙Command set which meets the logical specification of the SCSI CCS (Common Command Set for Direct Access Device) requirements (Rev. 4.B)

The SCSI commands can manipulate data through logical block addressing regardless of the physical characteristics of the disk drive. This allows software to accommodate future expansion of system functions.

(3)8-bit SCSI/16-bit SCSI

The IDD has 16-bit data bus width (16-bit SCSI), which have the wide transfer function suitable for SCSI-2. This is also available as 8-bit data bus.

∙8-bit SCSI: Up to eight SCSI devices can be connected on the same SCSI bus.

∙16-bit SCSI: Up to 16 SCSI devices can be connected on the same SCSI bus.

For the ultra SCSI model, number of connectable SCSI devices on the same SCSI bus is varied as follows.

∙Up to 4 SCSI devices having capacitance of 25 pF: Cable length of up to 3.0 m.

∙5 to 8 SCSI devices having capacitance of 25 pF: Cable length of up to 1.5 m

(4)High speed data transfer

∙ 8-bit SCSI:	The data transfer rate on the SCSI bus is 40 MB/s maximum in
	synchronous mode.

∙16-bit SCSI: The data transfer rate on the SCSI bus is 80 MB/s maximum in synchronous mode for LC/LP models and 160 MB/s maximum in synchronous mode for MC/MP models.

Such a high data transfer rate on the SCSI bus can be useful with the large capacity buffer in the IDD.

1 - 2 C141-E064-03EN