Fujitsu MAE3091LC, MAF3364LP, MAF3364LC, MAG3182LC Important Alert Items, Important Alert Messages

Important Alert Items

Important Alert Messages

The important alert messages in this manual are as follows:

A hazarous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. This alert signal also indicates that damages to the produt or other property, may occur if the user does not perform the procedure correctly.

Task	Alert message	Page
Mounting Installation	Heat	4-10
	An air flow with an adequate wind velocity must be maintained
	to deal with much heat generated from the MAF3364xx.
	Reference value: An air flow with a wind velocity of more than
	0.5 m/s is required in an environment at 40°C,
	and an air flow with a wind velocity of more
	than 1.0m/s in an environment at 45°C (Center
	of DE cover 55°C).
	Data loss	5-5
	1. The user must not change the setting of terminals not
	described in this section. Do not change setting status set at
	factory shipment.
	2. Do not change the setting of terminals except following
	setting pins during the power is turned on.
	• Write protect: CN2 9-10
	3. To short the setting terminal, use the short plug attached
	when the device is shipped from the factory.
	Damage	5-11
	1. Check that system power is off before connecting or
	disconnecting cables.
	2. Do not connect or disconnect cables when power is on.
	Data loss	6-4
	When the SEND DIAGNOSTIC command terminates with the
	CHECK CONDITION status, the INIT must collect the error
	information using the REQUEST SENSE command. The
	RECEIVE DIAGNOSTIC RESULTS command cannot read out
	the error information detected in the self-diagnostics.
	Damage	6-5
	Do not open the DE in the field because it is completely sealed.
	Data loss	6-6
	Save data stored on the disk drive before requesting repair.
	Fujitsu does not assume responsibility if data is destroyed
	during servicing or repair.

viii C141-E064-03EN