Fujitsu MAG3182FC, MAG3091FC Setting 5.2.1 Loop ID setting, Mode settings, 1 Motor start mode

5.2Setting

5.2.1Loop ID setting

When setting the fibre channel loop ID, use SEL0 to SEL6 of interface connector CN1. IN bit weighting, SEL6 corresponds to the MSB, SEL0 to the LSB, and 126 types of X'00' to X'7D' can be specified as loop IDs.

5.2.2Mode settings

(1)Motor start mode

The method for start control of the IDD spindle motor can be set in accordance with Table 5.1.

		Table 5.1 Motor start mode
Setting
Signal name
Start_2/Mated	Start_1/Mated	Start mode
Connector pin
CN1-10	CN1-09
Open	Open	The drive is not connected to the system. The drive does not start
		the spindle motor.
Open	GND	The drive is connected to the system. After recognizing the
		connection, the drive starts the spindle motor upon receipt of a
		START/STOP UNIT command.
GND	Open	The drive is connected to the system. After recognizing the
		connection, the drive starts the spindle motor after a prescribed
		delay time has elapsed.
GND	GND	The drive is connected to the system. The driver starts the spindle
		motor immediately after recognizing the connection.

IMPORTANT

Set the loop ID so that there are no duplicates between devices on the same loop.

C141-E078-02EN 5 - 3