Fujitsu MAG3091FC, MAF3364FC, MAG3182FC manual Safety Precautions, List of Important Precautions

SAFETY PRECAUTIONS

List of Important Precautions

CAUTION

This manual includes the following important precautions:

Indicates that either minor or moderate personal injury may occur or may cause damages to this product itself or property of other users if the user does not perform the procedure correctly.

Work division	Precaution	Page
Assembly/installation	Damage to drive	4-8
	A hole or screw portion as shown in Figure 4.8 is used for adjusting air
	pressure balance between inside and outside the DE. Do not fill with a
	seal or label.
	Seals on the DE prevent the DE inside from the dust. Do not damage or
	peel off labels.
	Damage	5-15
	1. When dismounting the drive which is mounted on the system while
	power is supplied to it.
	• The drive to be dismounted must be separated from the loop.
	Dismounting the drive which is not separated from the loop may
	cause an unexpected error.
	• If the drive is not separated from the loop, issue an LPB to the
	drive from the initiator in a primitive sequence of the order set.
	• It is recommended to stop the spindle motor prior to this loop
	separation operation. The spindle motor can be stopped by a
	START/STOP command. It takes about 30 seconds for the
	spindle motor to stop completely.
	• Then, dismount the drive using the drive mounting/dismounting
	mechanism, etc. of the system. If the drive is dismounted while
	the spindle motor is running, special care is required to avoid
	excessive vibration or shock to the drive. It is recommended to
	stop the operation once the SCA connector breaks off contact
	and wait until the spindle motor stops (about 30 seconds) before
	dismount the drive.
	• When storing or transporting the drive, put it in an antistatic
	bag. (Shown in Section 5.1).
	2. When dismounting the drive which is mounted on the system while
	power is not supplied to it
	• Do not move the drive until the drive stops completely (about 30
	seconds if the spindle motor was stopped by a START/STOP
	UNIT command, and about 30 seconds after powering-off when
	the power was simply turned off).
	• Then, dismount the drive using the drive mounting/dismounting
	mechanism, etc. of the system.
	• When storing or transporting the drive, put it in an antistatic
	bag. (Shown in Section 5.1).

viii C141-E078-02EN