Fujitsu MHC2040AT, MHC2032AT, MHD2021AT, MHD2032AT manual Flush Cache E7

5.3 Host Commands

Issuing this command in FROZEN MODE returns the Aborted Command error.

At command issuance (I-O register contents)

1F7h(CM)	1	1	1	1	0	0	0	1
1F6h(DH)	×	×	×	DV	xx
1F5h(CH)	xx
1F4h(CL)	xx
1F3h(SN)	xx
1F2h(SC)	xx
1F1h(FR)	xx

At command completion (I-O register contents)

1F7h(ST)	Status information
1F6h(DH)	×	×	×	DV	xx
1F5h(CH)	xx
1F4h(CL)	xx
1F3h(SN)	xx
1F2h(SC)	xx
1F1h(ER)	Error information

(34) FLUSH CACHE (E7)

This command is used to order to write every write cache data stored by the device into the medium. BSY bit is held at "1" until every data has been written normally or a error has occurred. The device performs every error recovery so that the data are read correctly.

When executing this command, the reading of the data may take several seconds if much data are to be read.

Complete execution of this command may take 30 seconds or over.

In case a non-recoverable error has occurred while the data is being read, the error generation address is put into the command block register before ending the command. This error sector is deleted from the write cache data, and the remaining cache data is written into the medium by the execution of the next Flush Cache command.

C141-E050-02EN 5-67