Setting Exhibition Mode Exhibition Mode

• Specifying RGB Input Signal (Code Setting)

You can use this option to specify and display the type of RGB input signal by code number.

Each time you press		or , one of the available choices appears in the following
sequence:
Auto		Manual
Auto:	Automatically displays the input signal to the optimum.
Manual: Selects RGB code number.
Press	to store.	“Code Setting” setting screen

*In Auto mode, the optimum resolution may not be set up automatically depending on the type of signal.

Select the type of signal when the image is not displayed properly.

However, note that when the type of signal is selected directly, the signal of other resolution may not be displayed properly.

You can use this option to display white over the entire screen to minimize phosphor burn-in.

Each time you press	or	, one of the available choices appears in the following sequence:
On	Off

Off: Does not display white.

On: Displays a white screen immediately.

Press to store.

You can use this option to display the enhanced contrast, which is most suitable for the use by unspecified persons.

Each time you press	or	, one of the available choices appears in the following sequence:
On	Off

On: Sets up Exhibition mode.

Off: Sets up normal mode.

Press to store.

*In Exhibition mode, the display returns to the original setting in about 5 minutes even if the adjustment is changed.

*The setup will be cancelled when removing the power plug from the receptacle.

• Displaying System Status (Information)
Displays system operation status.
Select “Information” and press		.
The “Information” screen will appear.
Mode:	Input mode appears at the upper right corner of the screen.
Freq. Scan Mode: Frequency scanning
Input Signal:	Video mode
Input Sync.:	Signal type	Information screen (Video Mode)

Freq.:	Frequency and polarity (fH, fV)
Preset No.:	RGB code number

Information screen (RGB Mode)

* On-screen information disappears if you do not take any action for about 60 seconds.

E-38