Cabletron Systems CSX1200 Out init data link slot #, port # , ces, Recall dial tone on, Tones off

TRACE MESSAGES

Call Trace Messages

Out - DL CFG Slot=<slot # > Port=<port #> Ces=<communication endpoint suffix> The system is initializing the indicated data link.

Out - DSL CFG Slot=<slot #> Port=<port #>

The system is initializing the indicated line.

Out - init data link <slot #, port # , ces>

The system is sending a message to the network to initialize a data link on an ISDN line. The <parameters> are used to report line details.

Out - PROCEEDING Call Id=<call Id> Slot=<slot #> Port=<port #> Chans=<bearer channel map> Ces=<communication endpoint suffix> ConnId=<connect Id>

The system is sending a connection to the network. This is sent in response to receiving a call indication. The <parameters> are included for your Distributor or Cabletron Customer Support.

Recall dial tone on

Informational call trace message.

Received charge amount - <charge amount>

The system has received an advice of charge from the network for the call just disconnected. The charge for this call is indicated in the charge amount parameter.

Received unknown abnormal report value Slot=<slot # > Port=<port # > Ces=<communication endpoint suffix>

Informational call trace message.

Received unknown progress value

Informational call trace message.

Received unknown signal value

Informational call trace message.

Ringback tone on

Informational call trace message.

Status report progress value received

Informational call trace message.

Stutter tone on

Informational call trace message.

Tones off

Informational call trace message.

Unspecified cause

Informational call trace message. This message is used to indicate additional details on the <cause value> received in the “call progress” information message.Refer to the Cause Codes Table for more information.

Unspecified tone

Informational call trace message. It is used to indicate additional details on the <signal value> received in the “call progress” information message. The <tone value> is displayed as one of the following: dial, ring back, answer, call waiting, off hook warning, custom, recall dial, stutter dial, or expensive routing.

Workgroup Remote Access Switch 493