Cabletron Systems CSX1000, CSX1200 manual Verifying IP Routing Over Interfaces

USER’S GUIDE

2.If a message similar to the following is displayed, the IP host mode feature over the specified LAN port is operational. Repeat this step for each LAN port on your Ethernet resource.

100.0.0.2is alive

3.If this message is not displayed, then the IP Host mode feature over the LAN connection is not operational. Refer to IP Host Mode Operation over the LAN Interface Connection in the Problem Diagnosis chapter.

4.Once IP Host Mode feature is operational on each LAN port on your Ethernet resource, then IP Host Mode feature over the LAN Connection is operational.

VERIFYING IP HOST MODE OPERATION OVER A WAN CONNECTION

The steps to verify the operation of IP Host mode feature over a WAN connection are:

1.Determine if a remote IP Host (Host B) can access the system. On the remote IP host type: ping 100.0.0.1

2.If a message similar to the following is displayed, the IP host mode feature over the specified WAN connection is operational.

100.0.0.1is alive

3.If this message is not displayed, then IP Host mode feature over the WAN connection is not operational. Refer to IP Host Mode Operation over the WAN Connection in the Problem Diagnosis chapter.

VERIFYING IP ROUTING OVER INTERFACES

The following sections provide a method of verifying that IP routing is operational over the available interfaces.

VERIFYING IP ROUTING OVER A LAN INTERFACE

To verify that IP routing is operating properly over the LAN connection, an IP host must be connected to the local LAN port on the CyberSWITCH. The host must be properly configured and operational on the IP network to which it is connected.

Below is an example of a configuration used to verify IP routing over a LAN connection. It uses IP addresses specific to the example. Substitute the IP addresses of your network when you perform the IP routing verification steps.

360 CyberSWITCH