Cabletron Systems CSX1200, CSX1000 manual Port LAN Adapter, operating in remote mode only

SYSTEM MESSAGES

System Message Summary

1 port LAN Adapter, operating in remote mode only

This is an initialization message. It identifies the Ethernet adapter type (Ethernet-1), and operating mode. Remote bridging is supported.

2 port LAN Adapter, operating in local and remote mode

This is an initialization message. It identifies the Ethernet adapter type (Ethernet-2), and operating mode. Both local and remote bridging are supported.

aarp found duplicate AppleTalk address <AppleTalk Address> @ <MAC address>

The address resolution protocol found duplicate AppleTalk addresses for this AppleTalk network. Check the configuration for the AppleTalk ports’ network range/number.

Abnormal response rcvd: <state msg reason cc state>

An unexpected message was received from a WAN interface card. The <parameters> included are for problem reporting purposes only. If the system fails to operate normally, or the warning continues to occur, contact your Distributor or Customer Support.

A call has exceeded the configured maximum duration

A call has been up longer than the amount of time configured. The next log message will inform the user whether or not the call has been taken down.

ACE authentication is not available. You must first ENABLE ACE user level authentication.

An attempt was made to configure the Terminal Server Security for ACE and ACE was not configured on the CyberSWITCH.

Adapter does not respond: adapter #’x’

The WAN card initialization subsystem encountered an error on the indicated adapter. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Adapter #’x’ failed to initialize

The operational software on the indicated adapter card failed to signal that initialization was completed. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Adapter #’x’ failed to respond from bootstrap

The WAN card initialization subsystem encountered an error on the indicated adapter while downloading the bootstrap program. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Adapter failed to respond while programming: adapter 'x'

The WAN card initialization subsystem encountered an error on the indicated adapter while programming the hardware. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Administrative Session using ACE does not support password change.

Passwords may only be changed via the ACE Server administrator initiation. During an administrative login, the user attempted to change password. ACE only supports password change initiated by ACE Server administrator.

AppleTalk routing initialized successfully.

This message is posted when the system AppleTalk routing feature has initialized successfully.

Workgroup Remote Access Switch 429